A rotten egg smell from the tap is alarming, but you can usually narrow down the cause with a few minutes of checking. The odor most often comes from hydrogen sulfide gas dissolved in the water. Which tap smells, and under what conditions, tells you more than the smell itself.
Start with the hot and cold taps
Run only the cold tap at a kitchen or utility sink for about a minute, then smell the water in a clean glass. Repeat with the hot tap only. Write down the result for each one, and note whether the water was run after the house had been unused for a while.
If only the hot water smells, the likely source is the water heater or the hot-side pipes, not the supply coming into the house. Many water heaters contain a sacrificial anode rod, and under some conditions sulfate-reducing bacteria in the tank can react with it to produce hydrogen sulfide. Heaters that have sat unused for a long stretch, or that are kept at lower temperatures, are more prone to this. Ask a plumber to inspect the anode rod and the tank before anyone adds treatment to the heater.
If both the hot and cold water smell, the cause is more likely in the water itself or in a treatment unit on the line. Check whether any filter, softener, or other unit was installed, serviced, or left idle for a long period. Filter media that sits wet for a long time can develop bacteria and odors, so an idle filter is a reasonable suspect.
Rule out a gas leak first
Natural gas has a sulfur-based odorant added so leaks can be noticed, and that smell is easy to confuse with hydrogen sulfide. If the odor is strongest near a gas appliance, the gas meter, or the basement, treat it as a possible gas leak. Leave the building without switching lights or appliances on or off, then call your gas utility or the emergency number from outside. Do this before you investigate the water.
Questions to ask before anyone opens the tank or tests the supply
Ask the plumber whether the anode rod and the tank were checked and what condition they were in. If the smell is on the cold side, ask the water tester whether the sample will be analyzed for hydrogen sulfide and bacteria, and who will read the results and explain them to you in writing. If a treatment company is involved, ask whether it will inspect the unit, flush or sanitize it, and what it will do if the odor returns after the visit. Confirm in writing whether a return visit is included.
What to avoid while you sort it out
Do not add bleach, shock chemicals, or other sanitizing products to the water heater or the supply without knowing the source and the correct procedure. Mixing products or overdosing can make the problem worse and can damage equipment. Running the tap longer may clear the odor from the lines for a while, but if it returns, the source is still there. Keep a short log with the tap, the time, and whether the water had been unused, because that log will help whoever you call to diagnose the problem faster.
When to bring in a professional
If the cold water smells, or if the odor persists after the water heater has been checked, a certified test of the supply is the way to confirm the cause. If you are shortlisting companies to test or treat the water, see how we score them in our ranking methodology so you know what the ratings do and do not measure.