A water treatment unit mostly runs without you, which is why a long absence can cause problems nobody notices until you return. Before you leave for a trip of several weeks, decide what the system should do while the house sits empty, and write it down so anyone checking on the place knows it too.

Ask the installer what an empty house needs

Many owners leave the house supply open and the unit in service, but that is not a universal answer. Check your owner's manual or call the installer and ask two things: whether the unit needs any setting or step for a long period with no water use, and whether it needs a manual regeneration or a recharge before you come back. Get the answer in writing or note the name of the person who gave it. Do not assume the answer from a neighbor's system.

Check the salt and the supply before you lock up

If your unit uses salt, look at the level in the brine tank and confirm it sits above the minimum mark. A tank that runs dry during your trip leaves the unit with nothing to work with when you return. Confirm you have the salt type the manual names, and do not add anything the manual does not list. Also confirm the water supply valve for the house is in the position you intend, and note where it is.

Write the bypass position on a card

Find the bypass valve and note which handle position means in service and which means bypassed. Someone checking on the house may move it while looking at a leak or a gauge and never move it back. Tape a short card near the valve that states the correct position and the date you left, without a calendar date that will go stale, and say simply 'Leave in service unless the installer says otherwise.'

Give the house-sitter a short list, not the manual

A visitor needs four things: where the main shutoff is, what a leak or an alarm looks like, whom to call, and what not to touch. Name the service company, the phone number on your paperwork, and the hours they answer. Write down the model and serial number so a call can be handled quickly. Tell the visitor not to adjust settings, add anything to the unit, or reset the controller. If they see water where it should not be, the shutoff comes first and the call comes second.

Look at everything connected to the treated line

The unit is only one part of the plumbing. Decide what to do about any other equipment on the treated line, such as an ice maker or a water heater, and follow the manufacturer's guidance for an unoccupied house. Before you lock up, look at the supply and drain connections for any sign of seepage, and photograph the controller or gauge so you have a baseline to compare against when you return.

When you return, inspect before you run the tap

Walk the house first. Look under the unit and along the drain line for moisture, and check the controller for any fault code or a wrong time. Run a cold tap for a few minutes to clear the line, then check the water the way you normally do. If the water tastes or feels different, or the unit shows a fault, do not assume it is fine because the faucet runs. Call the service company and tell them the unit sat idle during your absence, since that detail often helps them diagnose the problem.

If you do not yet have a company to call, the Top 6 Water Treatment Companies in Missouri list is a place to start, and the ranking methodology explains how those companies were compared.