Mineral scale that settles in a water heater tank does not look dramatic from the outside. The first signs usually show up as sound and as a change in how quickly hot water arrives. This guide covers the checks you can make yourself and what to write down before you decide whether to flush the tank, pay for service, or start talking about a replacement.

Listen for the sound while the burner or element runs

Turn on a hot water tap at a sink a few feet from the heater, then listen near the tank while it heats. Scale on the bottom traps water beneath it, and that trapped water boils under the layer and makes a rumble, tick, or popping sound. Note whether the sound happens every heating cycle or only sometimes, and whether it gets louder as the tank heats.

Compare how long hot water takes to arrive

Pick a routine you can repeat, such as a morning shower, and note how long the water takes to reach full heat and how long it stays hot. A tank with scale heats more slowly because the heat has to pass through the deposit, so the burner or element runs longer. If the same shower now runs cooler sooner than it used to, write that down with the day you noticed it. A written log makes a service call faster and helps you judge whether the change is steady or sudden.

Check the faucet aerators and the drain water

Unscrew one faucet aerator and look for grit, flakes, or a sandy film. Those bits can come from the same mineral load that is building up inside the tank. Then, with the heater shut down as described below, open the drain valve at the bottom of the tank into a bucket. Gritty, dark, or sandy water that keeps running points to sediment. Clear water that stops quickly suggests there is little to remove.

Shut the heater down before you touch the drain

Water inside the tank can be hot enough to scald. Before you open the drain valve, turn off the power at the breaker or the gas supply at the control, close the cold water supply valve at the top of the heater, and let the tank cool before you drain it. The owner's manual or the label on the unit lists the correct steps and the recommended flush interval, so find that document first. If the manual is missing, the manufacturer's website usually has a copy under your model number.

Decide between a flush, a service call, or a replacement

A flush removes loose sediment and sometimes restores the sound and the recovery time. Before you decide, ask yourself a few questions. Does the drain run clear after a full flush? Does the sound return within a short time? Is the unit old enough that its warranty may have expired, and does the repair estimate approach the cost of a new tank? If you call a plumber or service company, ask them to write down what they found, what they cleaned, and whether they checked the anode rod, which slows corrosion inside the tank. Ask them to note any sign of a leak or a failing heating element too.

What to keep for next time

Keep the model number, the serial number, the date of each flush, and any service notes in one place near the heater or in a folder you can find quickly. The next person who looks at the unit, whether you or a technician, will start with a clearer picture and spend less time guessing about the sound or the slow recovery.