A UV disinfection unit uses a lamp inside a quartz sleeve through which the water passes. When the lamp ages or fails, the unit needs a new one, and the job follows the same pattern on most models: isolate the power and water, open the chamber, swap the lamp, reset the unit's life counter, and confirm the unit runs. The steps below are general. Your model's manual sets the exact order, torque, and reset method, and it should win if anything here differs.
Before you open the chamber
Read the manual for your model. Confirm the replacement lamp matches the model number on the unit, and note whether the manual calls for gloves or a clean cloth when you handle the lamp and sleeve. Turn off power at the unit's switch and, if you can reach it, at the breaker. Shut off water or use the bypass as the manual describes, and expect some water in the chamber when you open it.
Remove and clean
Open the chamber as the manual shows, lift out the old lamp, and disconnect the wiring connector without forcing it. Look at the quartz sleeve. A film or cloudy patch means mineral buildup that reduces light reaching the water. Clean the sleeve with the method the manual allows, and avoid abrasives that can scratch it. Check the o-rings and seals for cracks or flattening. Note the condition of the old lamp, such as discolored ends or dark spots, so you can judge how the next change should go.
Install the new lamp and reset the counter
Seat the new lamp, connect the wiring, and close the chamber evenly. Many units track lamp life with a timer or counter that must be reset after a change. If you skip this step, the unit may warn too early, show the wrong status, or keep counting the old lamp's hours. Reset the counter exactly as the manual describes, and write down that you did it.
Restore water and power, then confirm
Restore water and power in the order the manual specifies. Watch the unit's ready or run indicator and check for any alarm. Look for leaks at the chamber, the seals, and the fittings. Confirm that water flow is normal and that the unit has not gone into bypass. If the indicator does not light, an alarm stays on, or you see a leak you cannot stop, shut the system down and call the service route rather than running it.
Safety and when to hand it off
UV light can injure eyes and skin, so keep the chamber closed whenever the unit has power, and never look at a running lamp. If the unit is wired in a way that makes it hard to isolate power safely, or if the work would involve the electrical supply, have a licensed electrician or the service company do it. Keep a note of when the lamp was changed on the unit or in your records, so the next change is planned rather than discovered when the indicator fails.