Most people compare water softeners by the purchase or installation quote. The bill that keeps arriving is the running cost: salt, the water used during regeneration, electricity, and sometimes drain or filter upkeep. Before you decide, find out which of these your household will actually pay and which ones a quote leaves out.
Salt is the cost you see most
Salt use depends mainly on how hard your water is, how much water your household uses, and how the unit is set to regenerate. Ion exchange softeners recharge their resin with a brine solution, and every recharge uses salt. Ask the seller how the regeneration setting was calculated. A setting based on a current hardness result and your household size will be more predictable than a setting copied from another house.
Ask: What hardness figure was the schedule built on, and what happens to the setting if the water test changes?
Water used in regeneration
Each regeneration flushes water through the resin bed. Units that regenerate on a fixed timer can run even when little water was used, which adds water use with no benefit. Units that regenerate based on measured use tend to waste less. Compare how each model decides when to regenerate, and ask for the water-use figure the manufacturer publishes for that exact model rather than an estimate from the installer.
Electricity and the drain
The control head draws a small amount of power continuously. For many homes the bigger issue is the drain. The regeneration discharge has to reach a drain that can handle it without backing up. A drain problem becomes a cost when it leads to a plumber visit or water damage. Check where the discharge line will go, whether it needs an air gap or standpipe, and who installs and checks it.
Why your own water numbers matter
Running cost climbs when the water is much harder than the setting assumes, because the unit regenerates more often or the resin is overloaded. Get a current hardness result from a lab or a reliable test kit and keep it with your paperwork so you can check any proposal against it.
What to compare before you buy
Ask each seller for the same five items: the expected monthly salt use based on your hardness result and household size, the water used per regeneration for the exact model, how the unit decides when to regenerate, the drain requirement, and what the ongoing cost includes beyond salt. Put the answers side by side. A low purchase price paired with high salt or water use can cost more over the life of the unit than a higher price with efficient regeneration.