A water softener relies on a brine tank full of salt and water. During each regeneration, the salt dissolves into a brine that flushes the resin. When the salt forms a hard crust, called a salt bridge, the water underneath can keep its level while the salt above never dissolves. The softener then runs its cycle without making fresh brine, and the resin stops getting recharged.
What the tank looks like when it fails
Open the brine tank lid or look through the window and compare the water level with the salt. In a working tank, the salt level drops gradually between refills and the water sits below the salt surface. In a tank with a bridge, you may see a hard layer of salt sitting well above the water, with an empty gap underneath. The salt level may look almost unchanged over several weeks even though the softener is still cycling.
Early signs at the fixtures
The first clue is often not the tank. Watch for soap that lathers poorly or returns to a dull film faster than usual, water spots that appear on glasses after a dishwasher cycle, or skin that feels tight after a shower. These happen gradually, so the change can be hard to notice week to week. Keep a simple note of when you last refilled salt and how the water feels, and compare the two.
Check it without climbing in
Do not put your head or body into the brine tank. Look through the lid, and if the crust is visible, follow the steps in your owner's manual for breaking it up. Most manuals ask for a wooden or plastic tool and a gentle poke at the crust, not a hammer or a metal bar that can damage the tank. If the manual does not describe this, ask the installer before you try it.
Prevent the next one
Keep the salt level within the range the manual gives, and avoid letting it run very low for long stretches. Ask the installer which salt type the unit was designed for, and keep the answer with your service records. Humid storage conditions can also affect how salt clumps, so a dry place is a practical choice.
When to call for help
If the crust returns quickly after you break it up, or if you notice the softener not regenerating on schedule, the problem may be a setting or a valve issue rather than the salt. Those checks belong with a technician who can see the control head and the valve. Note the symptoms and the dates you observed them so the technician can see the pattern.