A salt bridge is a hard crust of salt that forms in the brine tank above the water. The unit cannot draw brine from below the crust, so the tank can look full while the softener has little or no brine to work with. The result is hard water coming through the house with no obvious warning. Checking for bridges is a routine part of owning a softener.
What to look for each time you add salt
Each time you add salt, look into the brine tank before you pour. Note whether the salt level is dropping more slowly than usual, whether there is a visible gap between the salt and the water, and whether there is crust near the top. A brine level that stays high after several regenerations is a common sign to check further. Compare the water level against the fill line in your owner's manual, and do not add water above that mark.
How to break a bridge safely
If you find a bridge, use a wooden broom handle or a similar tool to gently push on the crust until it breaks. Work carefully and avoid striking the tank walls or the brine well. Do not use chemicals or solvents to dissolve the crust, and do not pour water into the tank to soften it, since that can overfill the tank. Once the crust breaks, the salt should settle. Run a manual regeneration and check that the brine draws down normally.
Salt type and fill habits
Use the type of salt the manufacturer lists for your unit. Some salts leave more insoluble material than others, which can add sediment to the bottom of the tank. Keep the salt level above the water and avoid letting the tank run completely empty. A steady fill habit does more to prevent bridges than most other steps.
A monthly look that takes a few minutes
Once a month, shine a flashlight into the brine tank. Confirm the salt is loose rather than hardened on top, that the water level sits at the right mark, and that there is no unusual sediment or odor. Keep a simple log of what you see so you can spot changes over time. If the crust keeps returning quickly, ask a service provider to check the brine setting and the salt you are using.
When to call for service
Call a service provider if bridges keep forming, if you see soft, sludgy material at the bottom of the tank, or if hard water returns after you have broken the bridge and run a regeneration. Those signs can point to a problem with the brine valve, the controller setting, or the water supply, and a bridge alone does not explain them.