The storage tank in a reverse osmosis system holds treated water under pressure, and its inner bladder keeps that water separated from the air charge that pushes it out to the faucet. When the air side drops, the faucet may sputter, run weak, or send out water more slowly than it used to. Checking the tank is simple, and it is one of the few maintenance tasks a homeowner can do without a service call.

Find the pressure figure for your tank

Look for the recommended air pressure on the tank label or in the owner's manual. Write that figure down and keep it with the manual. Do not guess a number from another brand, because tanks differ in how much air pressure they are designed to hold.

Drain the tank before you measure

A tank under water pressure will read falsely high. Close the tank's inlet shutoff valve, then open the treated water faucet and let the tank empty until the flow stops. Once the tank is drained, you can measure the air side accurately. Do not skip this step, because a reading taken on a full tank is not useful.

Check the air valve with a gauge

Use a tire-style pressure gauge on the air valve at the bottom of the tank. Compare the reading with the figure on the label or in the manual. If the number is low, add air slowly using the method in the manual, and recheck the gauge. Stop before you exceed the stated pressure. A tank that loses air quickly after you refill it may have a failed bladder, and that needs a service call.

Restore the tank and check the flow

Close the faucet, reopen the inlet shutoff valve, and let the tank fill. Run the faucet and check that the flow is steady rather than sputtering. Watch for drips at the tank fittings. A small leak at a fitting is worth fixing right away, while the unit is still easy to reach.

Keep the shutoff habits simple

Leave the tank's inlet shutoff open during normal use. Close it only for drainage, service or a repair. If the valve is hard to reach, mark it clearly so anyone in the house can find it. A closed shutoff left by mistake is one of the most common reasons a tank looks empty when the unit is actually working.

Keep a simple log

Write down each air check and the reading you found. A short log shows you how quickly the pressure changes and makes a sudden drop easy to spot. If the readings fall steadily, plan a service visit rather than waiting for the faucet to fail. Taste changes or slow output can have other causes, such as a clogged filter, so check the filter stages before you assume the tank is at fault.