Moving a water treatment system is less about the unit and more about the plumbing around it. The unit itself is often a manageable load, but the connections, drain line, and the new house's supply lines decide whether the job is simple or needs a professional. Before you touch anything, settle one question: does the equipment stay with the house or go with you? Check your sale or listing agreement. If the unit is owned by you, plan its removal. If it is included in the sale, leave it connected and document its condition for the buyer.

Tasks you can usually do yourself

Start by photographing every connection and the valve positions. Read the owner's manual for the shutdown sequence and the drain procedure. Close the supply shutoff, relieve pressure as the manual describes, and drain the unit as instructed. If the unit has removable media or brine, follow the manual for handling it. Once the lines are disconnected and the unit is empty, pack it upright and protected. Keep the manual and the model and serial information with the unit.

Tasks to hire out

Hire a licensed plumber for anything involving cutting or soldering pipe, adding or changing valves on the main supply, creating a new drain run, or connecting near the water heater. Those tasks affect the whole house's plumbing and can cause leaks or pressure problems that are expensive to fix later. Ask the plumber whether they will pull a permit where one is required, and check with your local building office about whether a permit applies to your project. Ask them to leak test the new connections before you rely on them.

At the new house

Before the unit goes in, confirm there is room, a suitable drain, and a power source if the unit needs one. Ask the plumber whether the new hookup needs a different fitting or a bypass installed. Follow the manual's restart sequence, watch every joint for weeps, and run water through the system slowly while you check. If any connection is dripping, shut the supply off and call the plumber back rather than tightening fittings under pressure.

Questions to ask the plumber

Ask whether they are licensed for this work in your area, whether they will pull any required permit, whether they will test the new connections, and whether they will put the work in writing. Those four answers tell you most of what you need to know about the job before it starts.