A water treatment unit usually gives no warning before its flow starts to slip. The tap still runs, the water still looks normal, and then one day the shower is weak. A pressure gauge log is a cheap way to see that slide coming. It takes a few minutes a month and gives you a set of numbers you can compare with each other, which tells you far more than a single reading.
What the numbers mean
A sediment or carbon cartridge creates resistance to flow. As debris collects on it, the resistance grows, and the pressure on the outlet side falls compared with the inlet side. That difference is called pressure drop. The gap between the two readings tells you how loaded the filter is. A softener or the pre-filter on a reverse osmosis system works the same way in its own part of the plumbing. Pressure drop does not tell you whether the water is safe or what is in it. It only tells you how hard the water has to work to get through.
What to install and where
You need two test points, one upstream of the unit and one downstream, with a gauge at each. Some installs include threaded test ports built into the plumbing. If yours does not, ask the installer whether ports can be added and where they would sit. Adding a port is a plumbing job. If it means cutting pipe or working on a line under pressure, hire a plumber rather than doing it yourself. A single gauge that you move between the two points also works, as long as you read it at the same port every time.
How to take a reading
Take readings on the same schedule and the same way each time. Open the same faucet, the one nearest the unit's outlet, to the same steady flow. A trickle and a full draw will give different numbers, so keep the flow consistent. Write down the upstream pressure, the downstream pressure, the difference between them, the day you read them, and anything that changed since the last reading, such as a houseful of guests, a new appliance, or a visit from a technician. Keep the log in a notebook or a note on your phone, and store it with the rest of the unit's paperwork.
Reading the trend
A gradual climb in the difference across several readings usually means the filter is loading with sediment. A sudden jump is different. It often means something changed in the plumbing, such as a valve that is not fully open, a bypass handle that was left partly turned, or a line that has picked up debris. Before you assume the unit is failing, check that every valve in the path is fully open and that the bypass is in service position. Then compare your upstream reading with the one you wrote earlier. If the upstream pressure itself has dropped, the cause is likely the supply or the street line, not the unit.
When to act
Check the owner's manual for the pressure drop limit the manufacturer lists for the cartridge or unit. If your readings are approaching that number, schedule the filter change the way the manual describes. If the drop passes the limit soon after a fresh cartridge, or a sudden jump does not clear after you have checked the valves, stop trying to diagnose it yourself and call the installer or the manufacturer. Give them your log. A few months of consistent numbers will help them find the problem faster than a description from memory.
Questions to ask your installer
Before you start the log, ask where the test points are, which readings they want you to take, what limit they recommend for your specific unit, and whether they will review the log at the next service visit. If the installer cannot give you the limit, ask the manufacturer's support line, and write the answer into the log so anyone who reads it later has it.