A water softener's control head decides when the unit regenerates, and regeneration is when most of the salt and water get used. Two broad control types are common. A timer control regenerates on a set schedule, such as every few days or at a chosen time of day. A metered control tracks how much water your household has used since the last regeneration and starts a cycle when the measured volume reaches a set point. Both can work well. The right one depends on how steady your water use is and how much you want to adjust settings yourself.
How each type behaves
A timer control is simpler to understand. It runs on the calendar whether or not much water was used, which can waste salt and water in a home with light or variable use, such as a household with people away for work or a vacation home. A metered control responds to actual flow, so a week of heavy laundry or guests tends to shift the cycle to match. The trade-off is that a metered control depends on a flow meter working correctly, and a meter problem can change how often the unit regenerates.
What to compare on the spec sheet
- What the control reads: calendar time, or water volume measured by a meter.
- How you set the system: whether the installer enters capacity, hardness, and salt dosage, and whether you can change them later without a technician.
- Whether you can see remaining capacity, the time of the next regeneration, and a history of past cycles.
- Whether programming is kept during a power outage, and for how long, and whether you must reset the clock after one.
- Whether you can start a manual regeneration with a button, and how the control tells you it is in bypass or showing a fault.
- How the meter is replaced if it fails, and whether that part is standard for the model.
Questions to ask before you choose
Ask the installer what hardness reading they used to set the programming, and whether that reading came from a test on your water or from a default. If the answer is a default, the setting may not match your supply. Ask what happens to the programming during an outage, and whether the unit needs a reset before it regenerates again. Ask how a meter failure would show up, so you know what to look for.
Ask whether the control can be adjusted by you, and whether the manual lists the settings you will be asked to choose. A control you cannot read or adjust is harder to check when the salt use seems wrong.
Comparing the people who sell these systems
Control type matters less than whether the company sets the unit correctly and explains how to check it. If you are comparing companies that offer either type, our ranking methodology explains how we score them, which can help you weigh how each one handles setup, follow-up, and service questions.