Cloudy water from the tap looks alarming, but it usually comes from one of three causes: dissolved air, suspended particles, or dissolved minerals. Each behaves differently, and you can tell them apart with a glass of water and some patience. Doing that check first tells you whether you need to wait, clean something, or call someone.

Run the glass test

Fill a clear drinking glass from the cold tap, one that has not been run recently, and set it on a counter where you can watch it for three to five minutes. Then look at what happens.

If the cloudiness starts at the top or the bottom and fades into clear water, it is dissolved air. Water under pressure holds air in solution, and when the pressure drops at the faucet, tiny bubbles form and make the water look milky. Air is harmless and clears on its own. It is more common after the water has been shut off for a while, after work on the supply line, or after a pump has run dry and restarted.

If the cloudiness settles to the bottom of the glass as grit or a fine layer, it is sediment. Sediment is particles carried in the water, such as sand, rust flakes, or debris from the pipe or the well. It does not clear, and you may see it collect as a film on the glass. Sediment usually comes and goes, or it may build up after the water system has been disturbed.

If the water stays hazy, does not clear, and leaves no settled layer, it is more likely dissolved minerals. Hard water can look like this, and so can some other dissolved substances. A haze that persists in the glass points toward a water-quality issue that a filter or softener is designed to address, not a clogged faucet.

Check whether it is one tap or the whole house

Next, run the cold water at a few different taps, including one outdoors or in a basement if you have one, and compare them. Then run the hot water at the same taps.

If only one faucet looks cloudy, check its aerator first. Unscrew the small screen at the tip of the faucet and look for grit or debris. Rinse it and put it back. Many cloudy-tap complaints end here, and it costs nothing to try.

If every tap looks cloudy and the glass test shows air that clears, the issue is probably temporary. If every tap shows sediment, the source is upstream of the faucets, so check any filter or screen on the main line and the pressure tank if you have one. If only the hot water is cloudy, the water heater may be stirring up sediment that has settled in the tank, which is a different question from the supply itself.

Note what changed

Before you do anything else, write down when the cloudiness started. Did it begin after work on the line, after the water was off for a while, after a filter change, or after the pump ran? The timing often tells you more than the appearance does. A sudden change after work on the pipes usually points to a temporary disturbance. A slow change over months, or a haze that has always been there, points to minerals or a filter that is no longer doing its job.

When to bring in a professional

Call a water treatment technician or a plumber if the cloudiness does not clear with the steps above, if it comes back quickly after you clean a filter or aerator, if the water has a strong smell or a color that does not fade, or if it shows up in several places at once without an obvious cause. Ask the technician to test the water, not only to look at the equipment. A test tells you what is actually in the water, and that answer decides which equipment fits.

If your home uses a private well, treat cloudy water with more caution. Do not assume it is only air, and do not drink it until you know it is safe. A water test from a certified laboratory is the reliable way to find out what is in it.

If the glass test points to minerals and you are comparing equipment next, the ranked list of local companies on the main page of this site is a practical place to start, and the scoring approach used there is explained on the methodology page.