A water softener does its work in the resin tank, but it depends on the brine tank to recharge that resin. The salt in the brine tank dissolves into water, and that brine is what carries the hardness out. When the salt stops dissolving, the softener can keep running on its timer and still deliver hard water. The brine tank is where you can spot that problem early.

What the salt is doing

Salt sits in a bed above a pool of water. As the water touches the salt, the salt dissolves into brine, and the brine is drawn into the resin during regeneration. The salt is consumed slowly, so the level drops over time. Your job is to keep salt in the tank and keep the water able to reach it.

Spot a bridge

A bridge is a hard crust of salt that forms over an empty space in the tank. The salt above looks full, but the water below cannot reach it, so the salt never dissolves. If you lift the lid and see a hollow under a solid top, you have a bridge. Do not assume a full-looking tank is a working tank.

Spot mush

Mush is the opposite problem: salt that has absorbed moisture, clumped together, and settled into a sludge at the bottom. It often looks like a dense paste or a layer of sand. Mush can block the brine valve and keep brine from forming properly. Look at the bottom of the tank as well as the top.

Keep the level in the right range

Keep salt above the water line and below the manufacturer's full mark. A tank packed too full is more likely to bridge, and one that runs low leaves the brine well with too little salt to draw from. Check the level on a schedule you set for your household, and check more often if the house uses more water.

Clear a bridge carefully

If you find a bridge, ask the company how they want it cleared before you touch it. Poking hard at the crust can damage the tank, crack the brine well, or drop debris into the brine line. A technician can tell you whether the tank needs cleaning.

Keep the path clear

Use the salt type the manufacturer lists for your unit, and do not add other products unless the manual says it is safe. Keep the lid closed to limit debris and dust. Make sure the float in the brine well moves freely, because a stuck float can make the tank look fine while the brine level is wrong.